Application steps
| 1. |
Pre-cleaning:
The surface must be free of oil, grease, salt, paint and other impurities. |
|
|
| 2. |
Blast cleaning:
Moulding sand, rust and sharp edges are removed. The graphite from the cast iron must be removed from the blasting material. |
|
|
| 3. |
Pre-heating:
This form of heating produces a uniform, defined temperature in the component. Any oxidation should be avoided. |
|
|
| 4. |
Coating application:
The coating is applied manually or automatically, in the shortest possible time - ideally within the gel time of the powder. |
|
|
| 5. |
Coating cure:
Achieved by the heat contained in the object, if the heating capacity of the work piece is sufficient.
|
Electrostatic Spray Application
Fluidized Bed Application
|
|
|